---

Aluminium et acier sont les matériaux utilisés pour cet outil.

Youtube https://youtu.be/Xk96SyufeLU?si=oIWcUwgXwxvTBvj7

G&W NUT AND SADDLE SANDER

The Nut and Saddle Sander holds the nut or saddle perfectly vertical while you roll it over sandpaper on a flat surface. Adjustment screws set the amount you want to remove, and in moments the piece is squared up and truly flat. Perfectly square nuts and saddles in seconds!

For solid contact and good tone, the bottom of a nut or saddle must be squared up. This "vise on wheels" is the fastest, surest way to do this.
Solves the tone trouble caused by poor fit.
Hand-sanding a nut or saddle, it's hard not to tilt it one direction or the other. The result is a poor fit in the slot—always a tone problem, but especially with undersaddle pickups.

Aluminum body with steel ball bearing rollersWorks with any nut/saddle material up to 82mm x 10mm.

How to use:
·Use sandpaper on a flat surface.
·Tighten the nut or saddle in the spring-loaded jaw.
·There are two sets of holes for the height adjusters: close for nuts, wide for saddles.
·Each mark on the height-adjusters equals approximately one tenth of a millimeter.
·When the wheels start turning, you’ve reached your preset height, and milled the nut or saddle flat.